Training to work with Hyuki DT4282 multimeter
To measure AC and DC voltages, which are called alternating and direct, respectively. First, set the multimeter selector to your liking. Then insert the connectors at the desired location when opening. Your Hyuki digital multimeter is now ready to measure voltage.
Investigation of DC and AC co-voltage and AC and DC voltage components
This quantity is a special feature of the Hyuki multimeter. To measure this parameter, we set the selector switch on the specified part, then the amount of co-voltage and the corresponding frequency appear on the screen.
Measurement of decibel and milliwatt voltage values
To measure the dBV and dBm parameters, set the selector to AC voltage. Then press the shift key. You will notice that the Hyuki multimeter, in addition to displaying the above values, also displays the desired operating frequency on its screen.
Measurement of connections in various wires, probes and circuits
To test short circuit in circuits or connections, as well as disconnection or lack of it in cables and other equipment that you want to make sure of their health, set the selector switch to the mode specified in the photo, the connectors on both sides of the basket Note: If there is an interconnection in the desired wire or cable, the Bezuk Hyuki multimeter will beep continuously.
When measuring this property with a Hyuki multimeter, you can determine the resistance threshold of the connection threshold.
The table below shows the selectivity threshold resistance and performance of the Hyuki digital multimeter.
Diode threshold voltage measurement and its health test
To activate this feature, Hyuki digital multimeter to measure the voltage of the threshold of the detection diode, put its pins and the selector switch in beep mode, then press the shift key.
When measuring the threshold voltage, the measuring ranges can be changed by the up and down arrow keys.
Resistance measurement in Hyuki digital multimeter
Follow the picture to measure the resistance values with a digital multimeter. Set the selector switch to the ohm mark, then measure the resistance by connecting the connectors to the two resistors. You can also change the measurement accuracy and tensor at any stage by pressing the range range button.
Rose Calibration Company in Melbourne, Australia with over ten years of experience provides all calibration, maintenance, and repair services throughout Australia. If you live in Sydney, Melbourne, Adelaide, Perth, Geelong, and Brisbane, you can receive your quote in less than two hours by fill-up the form via the “Booking” link.